Attractor3D QML Type

This property defines the duration in milliseconds how long it takes for particles to reach the attaction position. When the value is -1, particle lifeSpan is used as the duration.

The default value is -1.

This property defines the duration variation in milliseconds. The actual duration to reach attractor is between duration - durationVariation and duration + durationVariation.

The default value is 0 (no variation).

This property defines if the particle should disappear when it reaches the attractor.

The default value is false.

This property defines the variation on attract position. It can be used to not attract into a single point, but randomly towards a wider area. Here is an example how to attract particles into some random point inside (50, 50, 50) cube at position (100, 0, 0) within 2 to 4 seconds:

Attractor3D {
    position: Qt.vector3d(100, 0, 0)
    positionVariation: Qt.vector3d(50, 50, 50)
    duration: 3000
    durationVariation: 1000
}

The default value is (0, 0, 0) (no variation).

See Also▲

This property defines the amount of possible positions stored within the attractor shape. By default the amount equals the particle count, but a lower amount can be used for a smaller cache. Higher amount can be used for additional randomization.

This property defines a ParticleAbstractShape3D for particles attraction. Each particle will be attracted into a random position inside this shape. This is an alternative for defining position and positionVariation. Here is an example how to attract particles into some random point inside sphere by the end of the particles lifeSpan:

Attractor3D {
    position: Qt.vector3d(100, 0, 0)
    shape: ParticleShape3D {
        type: ParticleShape3D.Sphere
        fill: true
    }
}

See Also▲

This property defines if the attractor caches possible positions within its shape. Cached positions give less random results but are better for performance.

The default value is true.