QHostAddress Class Reference
[QtNetwork module]

QString QHostAddress::scopeId () const

Returns the scope ID of an IPv6 address. For IPv4 addresses, or if the address does not contain a scope ID, an empty QString is returned.

The IPv6 scope ID specifies the scope of reachability for non-global IPv6 addresses, limiting the area in which the address can be used. All IPv6 addresses are associated with such a reachability scope. The scope ID is used to disambiguate addresses that are not guaranteed to be globally unique.

IPv6 specifies the following four levels of reachability:

• Node-local: Addresses that are only used for communicating with services on the same interface (e.g., the loopback interface "::1").
• Link-local: Addresses that are local to the network interface (link). There is always one link-local address for each IPv6 interface on your host. Link-local addresses ("fe80...") are generated from the MAC address of the local network adaptor, and are not guaranteed to be unique.
• Site-local: Addresses that are local to the site / private network (e.g., the company intranet). Site-local addresses ("fec0...") are usually distributed by the site router, and are not guaranteed to be unique outside of the local site.
• Global: For globally routable addresses, such as public servers on the Internet.

When using a link-local or site-local address for IPv6 connections, you must specify the scope ID. The scope ID for a link-local address is usually the same as the interface name (e.g., "eth0", "en1") or number (e.g., "1", "2").

This function was introduced in Qt 4.1.

See also setScopeId().

 Q_IPV6ADDR addr = hostAddr.toIPv6Address();
 // addr contains 16 unsigned characters

 for (int i = 0; i < 16; ++i) {
     // process addr[i]
 }