QGradient Class

Qt currently supports three types of gradient fills:

• Linear gradients interpolate colors between start and end points.

• Simple radial gradients interpolate colors between a focal point and end points on a circle surrounding it.

• Extended radial gradients interpolate colors between a center and a focal circle.

• Conical gradients interpolate colors around a center point.

A gradient's type can be retrieved using the type() function. Each of the types is represented by a subclass of QGradient:

The colors in a gradient are defined using stop points of the QGradientStop type; i.e., a position and a color. Use the setColorAt() function to define a single stop point. Alternatively, use the setStops() function to define several stop points in one go. Note that the latter function replaces the current set of stop points.

It is the gradient's complete set of stop points (accessible through the stops() function) that describes how the gradient area should be filled. If no stop points have been specified, a gradient of black at 0 to white at 1 is used.

A diagonal linear gradient from black at (100, 100) to white at (200, 200) could be specified like this:

QLinearGradient linearGrad(QPointF(100, 100), QPointF(200, 200));
linearGrad.setColorAt(0, Qt::black);
linearGrad.setColorAt(1, Qt::white);

A gradient can have an arbitrary number of stop points. The following would create a radial gradient starting with red in the center, blue and then green on the edges:

QRadialGradient radialGrad(QPointF(100, 100), 100);
radialGrad.setColorAt(0, Qt::red);
radialGrad.setColorAt(0.5, Qt::blue);
radialGrad.setColorAt(1, Qt::green);

It is possible to repeat or reflect the gradient outside its area by specifying the spread method using the setSpread() function. The default is to pad the outside area with the color at the closest stop point. The currently set spread method can be retrieved using the spread() function. The QGradient::Spread enum defines three different methods: